EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

PA3GPU-9 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object PA3GPU-9. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*
1766742297	69 Count	197 Count
1766738694	68 Count	195 Count
1766735091	67 Count	188 Count
1766731505	66 Count	186 Count
1766727902	65 Count	184 Count
1766724299	64 Count	182 Count
1766720696	63 Count	180 Count
1766717094	62 Count	178 Count
1766713490	61 Count	171 Count
1766709903	60 Count	169 Count
1766706300	59 Count	167 Count
1766702698	58 Count	165 Count
1766688303	54 Count	152 Count
1766684700	53 Count	150 Count
1766681097	52 Count	148 Count
1766677494	51 Count	146 Count
1766673892	50 Count	144 Count
1766670289	49 Count	137 Count
1766669202	48 Count	137 Count
1766665599	47 Count	135 Count
1766661997	46 Count	133 Count
1766658394	45 Count	131 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)