EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP6PGH-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP6PGH-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1750255309	236 Count	830 Count	174 Count
1750253514	228 Count	815 Count	171 Count
1750251713	224 Count	804 Count	168 Count
1750249913	220 Count	791 Count	165 Count
1750248112	216 Count	777 Count	162 Count
1750246312	212 Count	761 Count	159 Count
1750244511	208 Count	748 Count	156 Count
1750242711	204 Count	735 Count	153 Count
1750240910	200 Count	721 Count	150 Count
1750239109	197 Count	708 Count	148 Count
1750237309	193 Count	695 Count	145 Count
1750233708	186 Count	671 Count	140 Count
1750231913	178 Count	658 Count	137 Count
1750230112	175 Count	646 Count	135 Count
1750228312	171 Count	632 Count	132 Count
1750226511	167 Count	618 Count	129 Count
1750224711	159 Count	587 Count	122 Count
1750222910	155 Count	565 Count	119 Count
1750221109	151 Count	548 Count	116 Count
1750219309	147 Count	531 Count	113 Count
1750217508	143 Count	514 Count	110 Count
1750215708	139 Count	498 Count	107 Count
1750213907	135 Count	478 Count	104 Count
1750212106	131 Count	457 Count	101 Count
1750210312	123 Count	442 Count	98 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)