EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ9PQL-00 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9PQL-00. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1762804494	118 Count	185 Count	84 Count
1762803590	115 Count	181 Count	82 Count
1762802686	112 Count	176 Count	80 Count
1762801783	109 Count	173 Count	78 Count
1762800878	106 Count	170 Count	76 Count
1762799974	103 Count	167 Count	74 Count
1762799070	100 Count	163 Count	72 Count
1762798167	97 Count	159 Count	70 Count
1762797263	94 Count	155 Count	68 Count
1762796359	91 Count	152 Count	66 Count
1762795456	88 Count	149 Count	64 Count
1762794552	85 Count	146 Count	62 Count
1762793648	82 Count	142 Count	60 Count
1762792745	79 Count	138 Count	58 Count
1762791841	75 Count	132 Count	55 Count
1762790937	61 Count	107 Count	42 Count
1762790034	37 Count	62 Count	19 Count
1762789130	35 Count	54 Count	18 Count
1762788226	33 Count	52 Count	17 Count
1762787323	31 Count	50 Count	16 Count
1762786418	29 Count	48 Count	15 Count
1762785515	27 Count	45 Count	14 Count
1762784609	25 Count	42 Count	13 Count
1762783705	23 Count	40 Count	12 Count
1762782893	22 Count	37 Count	12 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)