EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SR9BBC-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR9BBC-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1754210226	690 Count	511 Count	147 Count
1754209325	688 Count	510 Count	146 Count
1754208423	684 Count	509 Count	145 Count
1754207522	682 Count	508 Count	144 Count
1754206621	678 Count	507 Count	143 Count
1754205720	676 Count	506 Count	142 Count
1754204819	672 Count	505 Count	141 Count
1754203918	670 Count	504 Count	140 Count
1754203017	666 Count	503 Count	139 Count
1754202117	664 Count	502 Count	138 Count
1754201216	660 Count	501 Count	137 Count
1754200315	658 Count	500 Count	136 Count
1754199414	654 Count	499 Count	135 Count
1754198513	652 Count	498 Count	134 Count
1754197612	648 Count	497 Count	133 Count
1754196711	645 Count	495 Count	131 Count
1754195810	641 Count	494 Count	130 Count
1754194909	639 Count	493 Count	129 Count
1754194008	635 Count	492 Count	128 Count
1754193108	633 Count	491 Count	127 Count
1754192207	629 Count	490 Count	126 Count
1754191306	627 Count	489 Count	125 Count
1754190405	623 Count	488 Count	124 Count
1754189504	621 Count	487 Count	123 Count
1754188603	617 Count	486 Count	122 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)