EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

CR7BQX-13 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object CR7BQX-13. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*
1758397583	131 Count	757 Count
1758395777	129 Count	751 Count
1758393971	127 Count	745 Count
1758392165	125 Count	731 Count
1758390359	123 Count	725 Count
1758388623	117 Count	717 Count
1758386817	115 Count	711 Count
1758385011	113 Count	697 Count
1758383205	111 Count	691 Count
1758381400	109 Count	685 Count
1758379594	107 Count	679 Count
1758377788	105 Count	673 Count
1758375982	103 Count	667 Count
1758329168	43 Count	627 Count
1758327363	41 Count	621 Count
1758325556	39 Count	615 Count
1758323821	33 Count	607 Count
1758322016	31 Count	601 Count
1758320209	29 Count	495 Count
1758318403	27 Count	417 Count
1758316597	25 Count	411 Count
1758314791	23 Count	405 Count
1758312985	21 Count	399 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)