EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ7PKP-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ7PKP-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1779400887	217 Count	647 Count	47 Count
1779400286	216 Count	635 Count	47 Count
1779399084	211 Count	607 Count	44 Count
1779397883	208 Count	589 Count	43 Count
1779397282	206 Count	585 Count	42 Count
1779396080	203 Count	581 Count	41 Count
1779394278	198 Count	575 Count	39 Count
1779393077	196 Count	571 Count	39 Count
1779392475	194 Count	569 Count	38 Count
1779391274	192 Count	565 Count	38 Count
1779390673	191 Count	564 Count	38 Count
1779390072	189 Count	561 Count	37 Count
1779389471	188 Count	560 Count	37 Count
1779388870	187 Count	559 Count	37 Count
1779388270	186 Count	558 Count	37 Count
1779386467	182 Count	549 Count	36 Count
1779385266	180 Count	547 Count	36 Count
1779384665	179 Count	546 Count	36 Count
1779382290	171 Count	542 Count	36 Count
1779381089	169 Count	540 Count	36 Count
1779379286	166 Count	537 Count	36 Count
1779378085	164 Count	535 Count	36 Count
1779377484	163 Count	534 Count	36 Count
1779376282	161 Count	532 Count	36 Count
1779375081	159 Count	530 Count	36 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)