EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP3DVO-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP3DVO-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*
1783284965	40 Count	463 Count
1783284064	39 Count	454 Count
1783283164	38 Count	447 Count
1783282263	37 Count	436 Count
1783281362	36 Count	426 Count
1783280457	35 Count	416 Count
1783279573	34 Count	406 Count
1783278672	33 Count	396 Count
1783277771	32 Count	387 Count
1783276871	31 Count	380 Count
1783275970	30 Count	371 Count
1783275069	29 Count	360 Count
1783274169	28 Count	350 Count
1783273268	27 Count	340 Count
1783272367	26 Count	330 Count
1783271466	25 Count	320 Count
1783270566	24 Count	310 Count
1783269665	23 Count	300 Count
1783268764	22 Count	271 Count
1783267863	21 Count	235 Count
1783266963	20 Count	207 Count
1783266062	19 Count	197 Count
1783265161	18 Count	189 Count
1783264260	17 Count	180 Count
1783263360	16 Count	171 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)