EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

IT9IJY-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IT9IJY-12. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*
1758402557	16 Count	848 Count
1758398948	14 Count	787 Count
1758395387	12 Count	712 Count
1758391778	10 Count	651 Count
1758388170	8 Count	525 Count
1758384562	6 Count	443 Count
1758380953	4 Count	348 Count
1758377345	2 Count	190 Count
1758373787	0 Count	78 Count
1758370178	25 Count	997 Count
1758366570	23 Count	936 Count
1758362962	21 Count	792 Count
1758359353	19 Count	657 Count
1758355745	17 Count	573 Count
1758352185	15 Count	470 Count
1758348577	13 Count	421 Count
1758344969	11 Count	366 Count
1758341361	9 Count	315 Count
1758337751	7 Count	258 Count
1758334143	5 Count	199 Count
1758330586	3 Count	143 Count
1758326978	1 Count	71 Count
1758323370	23 Count	1007 Count
1758319762	21 Count	942 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)