EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

EA5DHO-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA5DHO-12. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1775498985	13 Count	966 Count
1775497665	13 Count	966 Count
1775496345	13 Count	966 Count
1775495025	13 Count	966 Count
1775493705	13 Count	966 Count
1775492385	13 Count	966 Count
1775491065	13 Count	966 Count
1775489745	13 Count	948 Count
1775488425	13 Count	913 Count
1775487942	13 Count	912 Count
1775486622	13 Count	910 Count
1775485302	13 Count	898 Count
1775483982	13 Count	876 Count
1775481342	13 Count	861 Count
1775480022	13 Count	861 Count
1775478702	13 Count	861 Count
1775477382	13 Count	859 Count
1775476062	13 Count	837 Count
1775474742	13 Count	819 Count
1775473422	13 Count	814 Count
1775472101	13 Count	814 Count
1775470781	13 Count	814 Count
1775469461	13 Count	814 Count
1775468141	13 Count	814 Count
1775466821	13 Count	812 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)