EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SR9EMP-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SR9EMP-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1790086485	30 Count	801 Count
1790084668	23 Count	584 Count
1790082867	4 Count	303 Count
1790081054	25 Count	1085 Count
1790079235	17 Count	900 Count
1790077434	7 Count	592 Count
1790075690	6 Count	416 Count
1790073890	1 Count	220 Count
1790072088	28 Count	1053 Count
1790070288	25 Count	864 Count
1790068471	6 Count	662 Count
1790066671	2 Count	496 Count
1790064854	1 Count	369 Count
1790063038	0 Count	188 Count
1790061227	16 Count	1026 Count
1790059426	11 Count	793 Count
1790057623	9 Count	620 Count
1790055822	4 Count	349 Count
1790054027	1 Count	173 Count
1790052227	19 Count	1034 Count
1790050426	15 Count	807 Count
1790048625	9 Count	473 Count
1790046824	5 Count	234 Count
1790045024	20 Count	1053 Count
1790043224	16 Count	864 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)