EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP6RJ-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP6RJ-12. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1785100649	500 Count	131 Count	131 Count
1785100045	497 Count	131 Count	131 Count
1785099443	494 Count	131 Count	131 Count
1785098839	491 Count	131 Count	131 Count
1785098236	488 Count	131 Count	131 Count
1785097633	485 Count	131 Count	131 Count
1785097030	482 Count	131 Count	131 Count
1785096427	479 Count	131 Count	131 Count
1785095221	473 Count	131 Count	131 Count
1785094618	470 Count	131 Count	131 Count
1785094015	467 Count	131 Count	131 Count
1785093412	464 Count	131 Count	131 Count
1785092809	461 Count	131 Count	131 Count
1785092205	458 Count	131 Count	131 Count
1785080283	387 Count	125 Count	125 Count
1785076168	359 Count	122 Count	122 Count
1785067725	313 Count	118 Count	118 Count
1785065916	304 Count	118 Count	118 Count
1785058680	267 Count	117 Count	117 Count
1785058077	258 Count	111 Count	111 Count
1785057581	249 Count	109 Count	109 Count
1785056978	246 Count	109 Count	109 Count
1785055772	240 Count	109 Count	109 Count
1785053365	226 Count	109 Count	109 Count
1785047937	185 Count	95 Count	95 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)