EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

EB5BZM-11 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EB5BZM-11. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1758389068	122 Count	822 Count
1758386965	120 Count	822 Count
1758384862	119 Count	822 Count
1758382758	118 Count	822 Count
1758380655	117 Count	822 Count
1758378552	116 Count	822 Count
1758376448	115 Count	822 Count
1758374345	114 Count	813 Count
1758372242	113 Count	763 Count
1758370139	111 Count	701 Count
1758368035	109 Count	692 Count
1758365932	108 Count	692 Count
1758363829	107 Count	677 Count
1758361725	106 Count	677 Count
1758359622	105 Count	667 Count
1758357519	104 Count	667 Count
1758355415	102 Count	637 Count
1758353312	101 Count	597 Count
1758351209	100 Count	597 Count
1758349105	99 Count	597 Count
1758347002	98 Count	597 Count
1758344899	97 Count	590 Count
1758342796	96 Count	582 Count
1758340692	95 Count	569 Count
1758338589	94 Count	558 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)