EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ9PL-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9PL-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1791440979	308 Count	971 Count	202 Count
1791439178	301 Count	947 Count	196 Count
1791437378	296 Count	915 Count	192 Count
1791435577	290 Count	878 Count	187 Count
1791433776	285 Count	851 Count	183 Count
1791431982	270 Count	822 Count	173 Count
1791430182	261 Count	798 Count	165 Count
1791428381	256 Count	774 Count	161 Count
1791426580	251 Count	753 Count	157 Count
1791424780	245 Count	718 Count	152 Count
1791422979	235 Count	685 Count	144 Count
1791421178	230 Count	661 Count	140 Count
1791415775	215 Count	583 Count	128 Count
1791413975	210 Count	557 Count	124 Count
1791412174	205 Count	539 Count	120 Count
1791410381	196 Count	514 Count	116 Count
1791408581	188 Count	481 Count	109 Count
1791406780	182 Count	458 Count	104 Count
1791404979	177 Count	435 Count	100 Count
1791403178	162 Count	396 Count	86 Count
1791401378	156 Count	373 Count	81 Count
1791399577	148 Count	339 Count	74 Count
1791397776	138 Count	310 Count	65 Count
1791395975	133 Count	275 Count	61 Count
1791394174	117 Count	226 Count	46 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)