EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SV1SSF-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SV1SSF-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1785093231	84 Count	203 Count	80 Count
1785091425	65 Count	165 Count	62 Count
1785089620	49 Count	125 Count	47 Count
1785087814	32 Count	84 Count	31 Count
1785086012	13 Count	42 Count	13 Count
1785084202	444 Count	1033 Count	420 Count
1785082397	426 Count	984 Count	403 Count
1785080591	410 Count	947 Count	388 Count
1785079044	396 Count	911 Count	375 Count
1785077239	379 Count	871 Count	359 Count
1785075433	360 Count	831 Count	341 Count
1785073628	346 Count	789 Count	328 Count
1785071822	330 Count	748 Count	313 Count
1785070017	312 Count	700 Count	296 Count
1785068212	296 Count	660 Count	281 Count
1785066406	278 Count	619 Count	264 Count
1785064601	262 Count	581 Count	249 Count
1785062793	242 Count	542 Count	230 Count
1785060988	224 Count	500 Count	213 Count
1785059182	207 Count	465 Count	197 Count
1785057376	191 Count	429 Count	182 Count
1785055571	174 Count	393 Count	166 Count
1785053765	154 Count	345 Count	147 Count
1785051960	134 Count	305 Count	128 Count
1785050155	116 Count	272 Count	111 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)