EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

4S7CRA-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object 4S7CRA-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1754410191	103 Count	361 Count	66 Count
1754409288	100 Count	351 Count	64 Count
1754408384	97 Count	341 Count	62 Count
1754407479	94 Count	332 Count	60 Count
1754406576	91 Count	321 Count	58 Count
1754405672	88 Count	312 Count	56 Count
1754404768	85 Count	302 Count	54 Count
1754403864	82 Count	292 Count	52 Count
1754402960	79 Count	284 Count	50 Count
1754402056	76 Count	274 Count	48 Count
1754401152	73 Count	264 Count	46 Count
1754400249	70 Count	255 Count	44 Count
1754399345	67 Count	246 Count	42 Count
1754398441	64 Count	238 Count	40 Count
1754397537	62 Count	228 Count	39 Count
1754396633	59 Count	218 Count	37 Count
1754395729	56 Count	205 Count	35 Count
1754394825	53 Count	191 Count	33 Count
1754394026	51 Count	184 Count	32 Count
1754393113	49 Count	175 Count	31 Count
1754392209	47 Count	164 Count	30 Count
1754391305	44 Count	156 Count	28 Count
1754390400	41 Count	147 Count	26 Count
1754389497	38 Count	138 Count	24 Count
1754388593	35 Count	129 Count	22 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)