EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ9S-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9S-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1783304434	83 Count	811 Count
1783302633	82 Count	794 Count
1783300833	81 Count	785 Count
1783299032	80 Count	769 Count
1783297232	79 Count	758 Count
1783295432	78 Count	746 Count
1783293630	77 Count	730 Count
1783291830	76 Count	717 Count
1783290029	75 Count	702 Count
1783288235	70 Count	684 Count
1783286434	69 Count	667 Count
1783284635	68 Count	650 Count
1783282833	67 Count	635 Count
1783281032	66 Count	620 Count
1783279232	65 Count	605 Count
1783277431	64 Count	594 Count
1783275632	63 Count	581 Count
1783273831	62 Count	571 Count
1783272030	61 Count	560 Count
1783270230	60 Count	548 Count
1783268429	59 Count	534 Count
1783266635	54 Count	520 Count
1783264833	53 Count	505 Count
1783263033	52 Count	489 Count
1783261232	51 Count	471 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)