EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP2WH-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2WH-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1762816720	189 Count	265 Count	169 Count
1762814920	172 Count	244 Count	153 Count
1762813119	157 Count	223 Count	139 Count
1762811318	141 Count	200 Count	124 Count
1762809518	124 Count	178 Count	108 Count
1762807717	107 Count	153 Count	92 Count
1762805917	100 Count	143 Count	86 Count
1762804116	80 Count	114 Count	67 Count
1762802315	74 Count	103 Count	62 Count
1762800515	69 Count	96 Count	58 Count
1762798714	63 Count	84 Count	53 Count
1762796914	57 Count	77 Count	49 Count
1762795139	50 Count	70 Count	46 Count
1762793338	44 Count	61 Count	41 Count
1762791538	26 Count	38 Count	24 Count
1762789737	18 Count	26 Count	17 Count
1762787936	7 Count	10 Count	7 Count
1762786136	696 Count	1006 Count	596 Count
1762784335	688 Count	992 Count	589 Count
1762782534	680 Count	982 Count	582 Count
1762780734	676 Count	976 Count	579 Count
1762778933	672 Count	971 Count	576 Count
1762777133	668 Count	964 Count	573 Count
1762775332	664 Count	957 Count	570 Count
1762773532	659 Count	950 Count	566 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)