EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

3Z2T-14 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object 3Z2T-14. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	Value1*	Value2*	Value4*	Value5*
1783295167	51	572	423	16
1783293370	50	561	423	16
1783291570	49	545	423	16
1783289770	48	535	423	16
1783287972	47	525	424	16
1783286172	46	514	424	16
1783284373	45	503	424	16
1783282573	44	493	425	16
1783280774	43	478	425	16
1783278974	42	468	425	71
1783277174	41	442	425	238
1783275376	40	434	425	256
1783273577	39	427	425	256
1783271778	38	421	425	256
1783269979	37	403	425	256
1783268180	36	397	425	256
1783266382	35	391	426	256
1783264582	34	385	425	256
1783262784	33	379	425	256
1783260984	32	373	425	256
1783259184	31	367	425	256
1783257386	30	361	425	256
1783255586	29	355	425	256
1783253786	28	345	425	256
1783251986	27	337	425	256

*Used Equation Coefficients:

Value1: 0, 1, 0

Value2: 0, 1, 0

Value3: 0, 1, 0

Value4: 0, 1, 0

Value5: 0, 1, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)