EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

F4IZM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F4IZM-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1791447635	867 Count	714 Count	479 Count
1791445846	866 Count	714 Count	479 Count
1791444023	865 Count	714 Count	479 Count
1791442219	844 Count	694 Count	459 Count
1791440414	834 Count	685 Count	450 Count
1791438609	833 Count	685 Count	450 Count
1791436804	832 Count	685 Count	450 Count
1791434999	831 Count	685 Count	450 Count
1791433194	830 Count	685 Count	450 Count
1791431389	829 Count	685 Count	450 Count
1791429584	828 Count	685 Count	450 Count
1791427780	827 Count	685 Count	450 Count
1791425972	825 Count	683 Count	449 Count
1791424167	824 Count	683 Count	449 Count
1791422362	823 Count	683 Count	449 Count
1791420557	822 Count	683 Count	449 Count
1791418752	821 Count	683 Count	449 Count
1791416947	819 Count	682 Count	448 Count
1791415142	818 Count	682 Count	448 Count
1791413337	817 Count	682 Count	448 Count
1791411532	816 Count	681 Count	448 Count
1791409845	815 Count	681 Count	448 Count
1791407979	814 Count	680 Count	448 Count
1791404423	812 Count	680 Count	448 Count
1791402496	811 Count	680 Count	448 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)