EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP2HCA-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2HCA-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1775487872	7 Count	131 Count	5 Count
1775486371	4 Count	79 Count	3 Count
1775484870	2 Count	36 Count	2 Count
1775483370	77 Count	1042 Count	43 Count
1775481869	75 Count	999 Count	42 Count
1775480368	72 Count	967 Count	40 Count
1775478867	70 Count	934 Count	39 Count
1775477367	68 Count	900 Count	38 Count
1775475866	66 Count	856 Count	37 Count
1775474365	62 Count	809 Count	34 Count
1775472865	57 Count	754 Count	30 Count
1775471364	54 Count	712 Count	28 Count
1775470773	48 Count	688 Count	27 Count
1775469272	46 Count	637 Count	26 Count
1775467771	44 Count	606 Count	25 Count
1775466271	41 Count	571 Count	23 Count
1775463269	37 Count	435 Count	21 Count
1775461769	34 Count	395 Count	19 Count
1775458767	30 Count	351 Count	17 Count
1775457266	27 Count	338 Count	15 Count
1775455766	25 Count	323 Count	14 Count
1775454265	23 Count	269 Count	13 Count
1775452764	20 Count	213 Count	11 Count
1775451264	17 Count	171 Count	9 Count
1775449171	9 Count	109 Count	7 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)