EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ4VW-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ4VW-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1785094734	104 Count	217 Count	40 Count
1785094433	102 Count	214 Count	40 Count
1785094132	100 Count	205 Count	39 Count
1785093831	97 Count	200 Count	38 Count
1785093531	96 Count	196 Count	38 Count
1785093230	93 Count	189 Count	37 Count
1785092929	91 Count	180 Count	36 Count
1785092628	89 Count	178 Count	36 Count
1785092328	87 Count	174 Count	35 Count
1785092027	84 Count	165 Count	34 Count
1785091726	83 Count	159 Count	34 Count
1785091425	80 Count	158 Count	33 Count
1785091124	78 Count	151 Count	32 Count
1785090824	76 Count	149 Count	32 Count
1785090523	74 Count	145 Count	31 Count
1785090222	65 Count	132 Count	24 Count
1785089922	58 Count	114 Count	18 Count
1785089621	55 Count	110 Count	17 Count
1785089320	53 Count	103 Count	16 Count
1785089019	51 Count	101 Count	16 Count
1785088719	49 Count	97 Count	15 Count
1785088418	46 Count	91 Count	14 Count
1785088117	45 Count	88 Count	14 Count
1785087816	42 Count	84 Count	13 Count
1785087516	40 Count	77 Count	12 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)