EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

EA4IAX-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EA4IAX-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*
1783289700	123 Count	920 Count
1783286100	118 Count	920 Count
1783282499	113 Count	920 Count
1783278896	108 Count	835 Count
1783275294	75 Count	784 Count
1783271691	69 Count	752 Count
1783268088	61 Count	711 Count
1783264485	56 Count	676 Count
1783260882	23 Count	650 Count
1783257279	18 Count	626 Count
1783253676	12 Count	586 Count
1783249514	11 Count	531 Count
1783245911	10 Count	490 Count
1783242308	9 Count	452 Count
1783238705	8 Count	419 Count
1783235102	7 Count	379 Count
1783231500	6 Count	335 Count
1783227896	5 Count	280 Count
1783224294	4 Count	224 Count
1783220691	3 Count	168 Count
1783217088	2 Count	112 Count
1783213485	1 Count	51 Count
1783206316	101 Count	960 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)