EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

CT2IKC-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object CT2IKC-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1754400827	427 Count	571 Count	331 Count
1754399024	422 Count	564 Count	327 Count
1754397220	417 Count	557 Count	323 Count
1754395417	412 Count	550 Count	319 Count
1754393613	407 Count	542 Count	315 Count
1754391809	402 Count	535 Count	311 Count
1754390006	397 Count	528 Count	307 Count
1754388202	392 Count	522 Count	303 Count
1754386399	387 Count	517 Count	299 Count
1754384637	382 Count	512 Count	295 Count
1754382833	377 Count	507 Count	291 Count
1754381030	372 Count	502 Count	287 Count
1754379226	367 Count	497 Count	283 Count
1754377423	362 Count	492 Count	279 Count
1754375619	357 Count	487 Count	275 Count
1754373816	352 Count	482 Count	271 Count
1754372012	347 Count	477 Count	267 Count
1754370208	342 Count	472 Count	263 Count
1754368405	337 Count	467 Count	259 Count
1754366601	332 Count	462 Count	255 Count
1754364798	327 Count	457 Count	251 Count
1754363037	322 Count	452 Count	247 Count
1754361233	317 Count	447 Count	243 Count
1754359430	312 Count	442 Count	239 Count
1754357626	307 Count	437 Count	235 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)