EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP6EFY-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP6EFY-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1750174324	75 Count	36 Count	36 Count
1750173118	72 Count	35 Count	35 Count
1750171912	68 Count	33 Count	33 Count
1750170706	65 Count	32 Count	32 Count
1750169607	62 Count	31 Count	31 Count
1750168401	59 Count	30 Count	30 Count
1750167195	55 Count	28 Count	28 Count
1750165989	52 Count	27 Count	27 Count
1750164783	49 Count	26 Count	26 Count
1750163576	45 Count	24 Count	24 Count
1750162370	42 Count	23 Count	23 Count
1750161164	39 Count	22 Count	22 Count
1750159959	35 Count	20 Count	20 Count
1750158753	32 Count	19 Count	19 Count
1750157547	29 Count	18 Count	18 Count
1750156341	25 Count	16 Count	16 Count
1750155135	22 Count	15 Count	15 Count
1750153929	17 Count	12 Count	12 Count
1750152723	10 Count	7 Count	7 Count
1750151517	4 Count	3 Count	3 Count
1750150311	1001 Count	633 Count	628 Count
1750149106	996 Count	630 Count	625 Count
1750148006	990 Count	626 Count	621 Count
1750146801	985 Count	623 Count	618 Count
1750145595	980 Count	620 Count	615 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)