EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ8RZE-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ8RZE-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1771566702	175 Count	321 Count	164 Count
1771565802	147 Count	258 Count	137 Count
1771564901	127 Count	198 Count	118 Count
1771564000	121 Count	187 Count	113 Count
1771563099	103 Count	157 Count	96 Count
1771562199	99 Count	150 Count	93 Count
1771561298	79 Count	122 Count	74 Count
1771560397	73 Count	110 Count	69 Count
1771559497	52 Count	80 Count	49 Count
1771558596	46 Count	68 Count	44 Count
1771557695	28 Count	44 Count	27 Count
1771556794	10 Count	20 Count	10 Count
1771555894	643 Count	1009 Count	593 Count
1771554993	625 Count	986 Count	576 Count
1771554092	619 Count	975 Count	571 Count
1771553192	601 Count	951 Count	554 Count
1771552291	592 Count	935 Count	546 Count
1771551390	572 Count	908 Count	527 Count
1771550490	567 Count	900 Count	523 Count
1771549589	551 Count	880 Count	508 Count
1771548688	531 Count	853 Count	489 Count
1771547788	526 Count	839 Count	485 Count
1771546903	505 Count	814 Count	469 Count
1771546002	489 Count	792 Count	454 Count
1771545101	466 Count	762 Count	432 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)