EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP9APJ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9APJ-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1771576353	26 Count	301 Count	24 Count
1771574552	18 Count	201 Count	17 Count
1771572752	10 Count	104 Count	10 Count
1771570951	95 Count	1027 Count	83 Count
1771569151	75 Count	913 Count	64 Count
1771567350	69 Count	857 Count	59 Count
1771565549	63 Count	789 Count	54 Count
1771563749	54 Count	722 Count	46 Count
1771561948	45 Count	581 Count	38 Count
1771560154	29 Count	428 Count	27 Count
1771558353	17 Count	274 Count	16 Count
1771556553	7 Count	144 Count	7 Count
1771554752	86 Count	1156 Count	73 Count
1771552951	76 Count	999 Count	64 Count
1771551151	68 Count	871 Count	57 Count
1771549350	59 Count	745 Count	49 Count
1771547549	50 Count	621 Count	41 Count
1771545749	41 Count	504 Count	33 Count
1771543948	36 Count	390 Count	29 Count
1771542148	28 Count	286 Count	22 Count
1771540347	21 Count	186 Count	16 Count
1771538553	10 Count	96 Count	10 Count
1771536752	90 Count	1067 Count	72 Count
1771534952	83 Count	985 Count	66 Count
1771533151	77 Count	886 Count	61 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)