EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

EB5KT-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object EB5KT-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1791467240	7 Count	947 Count
1791465437	6 Count	815 Count
1791463634	5 Count	728 Count
1791461831	4 Count	646 Count
1791460028	3 Count	562 Count
1791458225	2 Count	442 Count
1791456421	1 Count	299 Count
1791454618	0 Count	114 Count
1791452815	8 Count	1008 Count
1791451012	7 Count	905 Count
1791449209	6 Count	783 Count
1791447406	5 Count	650 Count
1791445638	4 Count	523 Count
1791443835	3 Count	408 Count
1791442032	2 Count	270 Count
1791440229	1 Count	170 Count
1791438426	0 Count	62 Count
1791436623	15 Count	1035 Count
1791434819	14 Count	975 Count
1791433016	13 Count	912 Count
1791431213	12 Count	835 Count
1791429410	11 Count	771 Count
1791427607	10 Count	707 Count
1791425804	9 Count	646 Count
1791424037	8 Count	573 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)