EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP5JWP-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP5JWP-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1754205424	70 Count	446 Count	49 Count
1754203624	64 Count	418 Count	45 Count
1754201823	58 Count	390 Count	41 Count
1754200022	52 Count	365 Count	37 Count
1754198222	45 Count	332 Count	32 Count
1754196421	37 Count	299 Count	27 Count
1754194620	29 Count	261 Count	21 Count
1754192820	20 Count	221 Count	15 Count
1754191019	14 Count	164 Count	11 Count
1754189218	7 Count	74 Count	6 Count
1754187418	167 Count	1021 Count	126 Count
1754185617	158 Count	948 Count	121 Count
1754183823	117 Count	829 Count	87 Count
1754182023	105 Count	735 Count	76 Count
1754180222	96 Count	648 Count	70 Count
1754178421	88 Count	560 Count	64 Count
1754176621	78 Count	478 Count	57 Count
1754174820	71 Count	406 Count	52 Count
1754173019	60 Count	332 Count	44 Count
1754171219	51 Count	254 Count	37 Count
1754169418	42 Count	186 Count	30 Count
1754167617	32 Count	124 Count	22 Count
1754165816	23 Count	82 Count	15 Count
1754164016	12 Count	44 Count	8 Count
1754162222	193 Count	1014 Count	142 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)