EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP1KRF-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP1KRF-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1750206748	372 Count	544 Count	151 Count
1750206694	372 Count	544 Count	151 Count
1750206676	372 Count	544 Count	151 Count
1750205782	370 Count	544 Count	151 Count
1750204581	366 Count	542 Count	149 Count
1750203379	363 Count	541 Count	148 Count
1750202178	360 Count	540 Count	147 Count
1750200976	356 Count	538 Count	145 Count
1750199774	353 Count	537 Count	144 Count
1750198573	350 Count	536 Count	143 Count
1750197372	346 Count	534 Count	141 Count
1750196170	343 Count	533 Count	140 Count
1750194968	340 Count	532 Count	139 Count
1750194418	339 Count	532 Count	139 Count
1750193663	337 Count	532 Count	139 Count
1750155052	336 Count	532 Count	139 Count
1750153851	332 Count	525 Count	137 Count
1750152649	329 Count	520 Count	136 Count
1750151448	325 Count	514 Count	134 Count
1750150247	322 Count	509 Count	133 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)