EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP2SGK-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2SGK-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1762809940	463 Count	509 Count	361 Count
1762809037	459 Count	505 Count	358 Count
1762808134	455 Count	501 Count	355 Count
1762807230	451 Count	495 Count	352 Count
1762806328	448 Count	491 Count	350 Count
1762805424	445 Count	487 Count	348 Count
1762804522	441 Count	483 Count	345 Count
1762803619	437 Count	479 Count	342 Count
1762802715	434 Count	475 Count	340 Count
1762801812	432 Count	473 Count	339 Count
1762800909	429 Count	469 Count	337 Count
1762800006	426 Count	465 Count	335 Count
1762799103	423 Count	461 Count	333 Count
1762798200	420 Count	458 Count	331 Count
1762797297	415 Count	450 Count	327 Count
1762796394	411 Count	444 Count	324 Count
1762795491	408 Count	440 Count	322 Count
1762794588	405 Count	436 Count	320 Count
1762793685	402 Count	432 Count	318 Count
1762792782	399 Count	428 Count	316 Count
1762791879	396 Count	424 Count	314 Count
1762791048	391 Count	417 Count	310 Count
1762790145	388 Count	413 Count	308 Count
1762789242	384 Count	407 Count	305 Count
1762788339	380 Count	403 Count	302 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)