EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP9KKK-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP9KKK-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1775499529	29 Count	659 Count
1775498628	24 Count	579 Count
1775497727	22 Count	555 Count
1775496826	19 Count	473 Count
1775495925	17 Count	397 Count
1775495025	13 Count	371 Count
1775494124	11 Count	287 Count
1775493366	6 Count	134 Count
1775493222	8 Count	213 Count
1775492321	6 Count	134 Count
1775491421	2 Count	66 Count
1775490519	32 Count	1006 Count
1775489618	29 Count	939 Count
1775488717	27 Count	857 Count
1775487816	24 Count	784 Count
1775486915	22 Count	696 Count
1775486014	19 Count	617 Count
1775485113	18 Count	573 Count
1775484212	14 Count	440 Count
1775483311	12 Count	418 Count
1775482410	9 Count	331 Count
1775481509	7 Count	243 Count
1775480608	3 Count	155 Count
1775479707	2 Count	72 Count
1775478806	46 Count	1074 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)