EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP2ROC-14 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2ROC-14. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1791446419	96 Count	348 Count	77 Count
1791446059	93 Count	343 Count	75 Count
1791445698	87 Count	326 Count	70 Count
1791445337	85 Count	311 Count	69 Count
1791444977	81 Count	294 Count	66 Count
1791444616	78 Count	285 Count	64 Count
1791444256	75 Count	278 Count	62 Count
1791443895	68 Count	264 Count	56 Count
1791443535	63 Count	251 Count	52 Count
1791443174	58 Count	242 Count	48 Count
1791442453	46 Count	217 Count	38 Count
1791442092	37 Count	201 Count	30 Count
1791441732	33 Count	184 Count	27 Count
1791441371	27 Count	155 Count	22 Count
1791441011	24 Count	113 Count	20 Count
1791440650	20 Count	89 Count	17 Count
1791439929	10 Count	29 Count	9 Count
1791439568	3 Count	14 Count	3 Count
1791439208	310 Count	1009 Count	233 Count
1791438847	306 Count	997 Count	230 Count
1791438487	301 Count	972 Count	226 Count
1791438126	296 Count	940 Count	222 Count
1791437765	290 Count	922 Count	217 Count
1791437405	287 Count	908 Count	215 Count
1791437044	283 Count	892 Count	212 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)