EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP8MB-L Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP8MB-L. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1766725171	419 Count	34 Count	34 Count
1766725050	418 Count	34 Count	34 Count
1766724929	417 Count	34 Count	34 Count
1766724809	416 Count	34 Count	34 Count
1766724688	415 Count	34 Count	34 Count
1766724567	414 Count	34 Count	34 Count
1766724447	413 Count	34 Count	34 Count
1766724325	411 Count	33 Count	33 Count
1766724204	410 Count	33 Count	33 Count
1766724083	409 Count	33 Count	33 Count
1766723963	408 Count	33 Count	33 Count
1766723842	407 Count	33 Count	33 Count
1766723721	406 Count	33 Count	33 Count
1766723600	405 Count	33 Count	33 Count
1766723479	404 Count	33 Count	33 Count
1766723398	402 Count	32 Count	32 Count
1766723277	401 Count	32 Count	32 Count
1766723155	400 Count	32 Count	32 Count
1766723035	399 Count	32 Count	32 Count
1766722914	398 Count	32 Count	32 Count
1766722793	397 Count	32 Count	32 Count
1766722672	396 Count	32 Count	32 Count
1766722551	395 Count	32 Count	32 Count
1766722430	394 Count	32 Count	32 Count
1766722310	393 Count	32 Count	32 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)