EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SO9G-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SO9G-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1775498881	31 Count	214 Count	26 Count
1775497080	22 Count	182 Count	18 Count
1775495280	17 Count	157 Count	14 Count
1775493479	13 Count	125 Count	11 Count
1775491678	9 Count	86 Count	8 Count
1775489878	3 Count	38 Count	3 Count
1775488077	148 Count	1001 Count	118 Count
1775486277	145 Count	969 Count	116 Count
1775482681	133 Count	792 Count	106 Count
1775480880	127 Count	730 Count	101 Count
1775479080	123 Count	699 Count	98 Count
1775477279	118 Count	673 Count	94 Count
1775475479	110 Count	620 Count	87 Count
1775473678	104 Count	589 Count	82 Count
1775471878	100 Count	572 Count	79 Count
1775470077	96 Count	549 Count	76 Count
1775468276	93 Count	535 Count	74 Count
1775466476	88 Count	517 Count	70 Count
1775464675	85 Count	503 Count	68 Count
1775462881	81 Count	487 Count	65 Count
1775461080	76 Count	475 Count	61 Count
1775459279	73 Count	460 Count	59 Count
1775457479	70 Count	449 Count	57 Count
1775455678	66 Count	426 Count	54 Count
1775453878	60 Count	374 Count	49 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)