EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ2WSZ-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2WSZ-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1785101499	277 Count	639 Count	216 Count
1785100898	276 Count	636 Count	216 Count
1785100298	270 Count	624 Count	211 Count
1785099697	265 Count	614 Count	207 Count
1785099096	263 Count	610 Count	206 Count
1785098495	258 Count	598 Count	202 Count
1785097895	252 Count	588 Count	197 Count
1785097294	251 Count	582 Count	197 Count
1785096693	246 Count	573 Count	193 Count
1785096092	244 Count	567 Count	192 Count
1785095491	242 Count	565 Count	191 Count
1785094891	236 Count	554 Count	186 Count
1785094290	231 Count	541 Count	182 Count
1785093689	230 Count	541 Count	182 Count
1785093088	224 Count	529 Count	177 Count
1785092488	221 Count	523 Count	175 Count
1785091887	219 Count	517 Count	174 Count
1785091286	213 Count	497 Count	169 Count
1785090686	208 Count	483 Count	165 Count
1785090085	207 Count	481 Count	165 Count
1785089484	201 Count	467 Count	160 Count
1785088883	194 Count	449 Count	154 Count
1785088283	192 Count	447 Count	153 Count
1785087682	188 Count	433 Count	150 Count
1785087081	184 Count	423 Count	147 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)