EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

2M0JUM-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object 2M0JUM-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1779472548	119 Count	66 Count	66 Count
1779470745	118 Count	66 Count	66 Count
1779468941	117 Count	66 Count	66 Count
1779467138	116 Count	66 Count	66 Count
1779465335	115 Count	66 Count	66 Count
1779463531	114 Count	66 Count	66 Count
1779461728	111 Count	64 Count	64 Count
1779459925	101 Count	55 Count	55 Count
1779458122	100 Count	55 Count	55 Count
1779456319	95 Count	51 Count	51 Count
1779454553	94 Count	51 Count	51 Count
1779452750	93 Count	51 Count	51 Count
1779450947	92 Count	51 Count	51 Count
1779449144	85 Count	45 Count	45 Count
1779447341	77 Count	38 Count	38 Count
1779445538	76 Count	38 Count	38 Count
1779443734	75 Count	38 Count	38 Count
1779441931	74 Count	38 Count	38 Count
1779440128	73 Count	38 Count	38 Count
1779438325	72 Count	38 Count	38 Count
1779436522	71 Count	38 Count	38 Count
1779434719	70 Count	38 Count	38 Count
1779411352	31 Count	12 Count	12 Count
1779409549	30 Count	12 Count	12 Count
1779407746	29 Count	12 Count	12 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)