EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

IU3ISP-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IU3ISP-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1775499905	142 Count	798 Count	92 Count
1775498101	137 Count	794 Count	88 Count
1775496297	132 Count	790 Count	84 Count
1775494493	128 Count	787 Count	81 Count
1775492689	122 Count	782 Count	76 Count
1775490885	120 Count	781 Count	75 Count
1775487278	113 Count	711 Count	70 Count
1775485474	110 Count	685 Count	68 Count
1775483714	104 Count	678 Count	67 Count
1775480106	99 Count	664 Count	64 Count
1775478302	97 Count	663 Count	63 Count
1775474694	92 Count	644 Count	60 Count
1775472890	90 Count	639 Count	59 Count
1775471087	87 Count	628 Count	57 Count
1775463871	76 Count	560 Count	50 Count
1775462111	69 Count	522 Count	48 Count
1775460307	67 Count	512 Count	47 Count
1775458503	64 Count	509 Count	45 Count
1775442268	31 Count	238 Count	21 Count
1775440504	22 Count	211 Count	17 Count
1775438700	18 Count	184 Count	14 Count
1775435093	11 Count	115 Count	9 Count
1775429681	245 Count	1015 Count	151 Count
1775427877	240 Count	983 Count	147 Count
1775424270	231 Count	910 Count	140 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)