EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ2MO-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ2MO-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 >>

Time	TX*	RX*	Digi*
1766723750	66 Count	240 Count	19 Count
1766722549	65 Count	235 Count	19 Count
1766721358	59 Count	230 Count	18 Count
1766720158	56 Count	222 Count	16 Count
1766718957	54 Count	216 Count	15 Count
1766717756	52 Count	206 Count	14 Count
1766716556	49 Count	200 Count	12 Count
1766715355	47 Count	194 Count	11 Count
1766714154	45 Count	188 Count	10 Count
1766712954	42 Count	182 Count	8 Count
1766711753	40 Count	175 Count	7 Count
1766710553	38 Count	168 Count	6 Count
1766709352	36 Count	160 Count	5 Count
1766708151	34 Count	154 Count	4 Count
1766706951	32 Count	144 Count	3 Count
1766705750	30 Count	133 Count	2 Count
1766704550	28 Count	124 Count	1 Count
1766703349	27 Count	118 Count	1 Count
1766702148	26 Count	111 Count	1 Count
1766700948	25 Count	104 Count	1 Count
1766699758	19 Count	98 Count	0 Count
1766697356	17 Count	78 Count	0 Count
1766696156	16 Count	64 Count	0 Count
1766694955	15 Count	52 Count	0 Count
1766693755	14 Count	43 Count	0 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)