EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SP1GDK-6 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP1GDK-6. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1762810958	800 Count	178 Count
1762810352	799 Count	178 Count
1762809746	798 Count	177 Count
1762809140	797 Count	176 Count
1762808533	796 Count	176 Count
1762807927	795 Count	175 Count
1762807321	794 Count	174 Count
1762806715	793 Count	174 Count
1762806109	792 Count	173 Count
1762805503	791 Count	172 Count
1762804896	790 Count	172 Count
1762804290	789 Count	171 Count
1762803684	788 Count	170 Count
1762803078	787 Count	170 Count
1762802472	786 Count	169 Count
1762801866	785 Count	168 Count
1762801259	784 Count	168 Count
1762800653	783 Count	167 Count
1762800046	782 Count	166 Count
1762799440	781 Count	166 Count
1762798834	780 Count	166 Count
1762798228	779 Count	165 Count
1762797848	778 Count	165 Count
1762797241	777 Count	164 Count
1762796634	776 Count	164 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)