EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ9KFZ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9KFZ-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1758389894	140 Count	1006 Count	101 Count
1758388994	136 Count	979 Count	98 Count
1758388093	132 Count	951 Count	95 Count
1758387192	129 Count	921 Count	93 Count
1758386292	125 Count	893 Count	90 Count
1758385391	121 Count	865 Count	87 Count
1758384490	117 Count	841 Count	84 Count
1758383590	114 Count	818 Count	82 Count
1758382689	110 Count	794 Count	79 Count
1758381788	106 Count	772 Count	76 Count
1758380888	102 Count	746 Count	73 Count
1758379987	98 Count	727 Count	70 Count
1758379086	94 Count	705 Count	67 Count
1758378186	90 Count	684 Count	64 Count
1758377285	86 Count	661 Count	61 Count
1758376384	82 Count	638 Count	58 Count
1758375484	78 Count	612 Count	55 Count
1758374583	74 Count	593 Count	52 Count
1758373682	70 Count	573 Count	49 Count
1758372782	66 Count	557 Count	46 Count
1758371881	63 Count	542 Count	44 Count
1758370980	61 Count	534 Count	43 Count
1758370079	57 Count	512 Count	40 Count
1758369178	55 Count	491 Count	39 Count
1758368277	51 Count	469 Count	36 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)