EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

IZ2WZM-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object IZ2WZM-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1754212415	20 Count	479 Count
1754211510	19 Count	445 Count
1754210606	18 Count	415 Count
1754209701	17 Count	404 Count
1754208797	16 Count	382 Count
1754207892	15 Count	359 Count
1754206988	14 Count	341 Count
1754206085	13 Count	318 Count
1754205179	12 Count	292 Count
1754204274	11 Count	279 Count
1754203370	10 Count	263 Count
1754202465	9 Count	222 Count
1754201560	8 Count	196 Count
1754200655	7 Count	183 Count
1754199750	6 Count	118 Count
1754198846	5 Count	102 Count
1754197941	4 Count	91 Count
1754197037	3 Count	57 Count
1754196132	2 Count	46 Count
1754195228	1 Count	24 Count
1754194323	0 Count	9 Count
1754193419	45 Count	1004 Count
1754192514	44 Count	983 Count
1754191609	43 Count	969 Count
1754190705	42 Count	949 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)