EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

GM4HYG-3 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object GM4HYG-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1775499939	278 Count	367 Count	168 Count
1775499036	276 Count	366 Count	167 Count
1775498132	274 Count	365 Count	166 Count
1775497229	272 Count	364 Count	165 Count
1775496325	270 Count	363 Count	164 Count
1775495422	268 Count	362 Count	163 Count
1775494518	266 Count	361 Count	162 Count
1775493614	264 Count	360 Count	161 Count
1775492711	262 Count	359 Count	160 Count
1775491807	258 Count	356 Count	157 Count
1775490903	256 Count	355 Count	156 Count
1775490000	253 Count	353 Count	154 Count
1775489096	243 Count	328 Count	145 Count
1775488193	217 Count	281 Count	120 Count
1775487289	213 Count	277 Count	117 Count
1775485482	186 Count	228 Count	92 Count
1775484579	184 Count	227 Count	91 Count
1775483675	182 Count	220 Count	90 Count
1775482772	180 Count	219 Count	89 Count
1775481868	178 Count	218 Count	88 Count
1775480964	176 Count	216 Count	87 Count
1775480061	174 Count	212 Count	86 Count
1775479236	167 Count	209 Count	84 Count
1775478333	160 Count	191 Count	78 Count
1775477429	158 Count	187 Count	77 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)