EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

OK1OBR-12 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK1OBR-12. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1791455860	436 Count	336 Count	133 Count
1791455029	435 Count	336 Count	133 Count
1791453225	434 Count	335 Count	133 Count
1791451421	433 Count	335 Count	133 Count
1791449618	432 Count	334 Count	133 Count
1791447814	431 Count	334 Count	133 Count
1791446010	430 Count	333 Count	133 Count
1791444206	429 Count	333 Count	133 Count
1791442402	428 Count	332 Count	133 Count
1791397442	401 Count	319 Count	131 Count
1791395638	400 Count	318 Count	131 Count
1791393835	399 Count	318 Count	131 Count
1791392031	398 Count	317 Count	131 Count
1791390227	395 Count	315 Count	129 Count
1791388423	394 Count	314 Count	129 Count
1791386619	393 Count	314 Count	129 Count
1791384815	388 Count	309 Count	125 Count
1791383011	383 Count	305 Count	121 Count
1791381207	380 Count	302 Count	119 Count
1791379404	377 Count	300 Count	117 Count
1791377600	370 Count	294 Count	111 Count
1791375842	369 Count	294 Count	111 Count
1791374038	368 Count	294 Count	111 Count
1791372234	367 Count	294 Count	111 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)