EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ9SIM-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9SIM-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

Time	TX*	RX*	Digi*
1779400928	905 Count	350 Count	332 Count
1779397326	903 Count	350 Count	332 Count
1779393725	901 Count	350 Count	332 Count
1779390123	899 Count	350 Count	332 Count
1779386521	897 Count	350 Count	332 Count
1779382920	895 Count	350 Count	332 Count
1779379338	892 Count	349 Count	331 Count
1779375736	890 Count	349 Count	331 Count
1779372134	888 Count	349 Count	331 Count
1779368533	886 Count	349 Count	331 Count
1779364931	881 Count	346 Count	328 Count
1779361330	875 Count	342 Count	324 Count
1779357728	869 Count	338 Count	320 Count
1779354126	863 Count	334 Count	316 Count
1779350525	857 Count	330 Count	312 Count
1779346923	847 Count	322 Count	304 Count
1779343322	841 Count	318 Count	300 Count
1779339719	834 Count	313 Count	295 Count
1779336136	832 Count	313 Count	295 Count
1779332534	830 Count	313 Count	295 Count
1779328933	828 Count	313 Count	295 Count
1779325331	826 Count	313 Count	295 Count
1779321729	824 Count	313 Count	295 Count
1779318128	822 Count	313 Count	295 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)