EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

F4JTC-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object F4JTC-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*	Digi*
1771576993	297 Count	384 Count	182 Count
1771576689	295 Count	382 Count	181 Count
1771576386	294 Count	379 Count	181 Count
1771576083	290 Count	376 Count	178 Count
1771575476	284 Count	367 Count	174 Count
1771575173	283 Count	365 Count	174 Count
1771574869	279 Count	361 Count	171 Count
1771574566	277 Count	359 Count	170 Count
1771574262	274 Count	355 Count	168 Count
1771573959	272 Count	352 Count	167 Count
1771573656	266 Count	346 Count	162 Count
1771573352	257 Count	336 Count	154 Count
1771573049	254 Count	332 Count	152 Count
1771572746	251 Count	329 Count	150 Count
1771572442	247 Count	323 Count	147 Count
1771572139	245 Count	319 Count	146 Count
1771571835	243 Count	315 Count	145 Count
1771571529	238 Count	305 Count	141 Count
1771571226	236 Count	302 Count	140 Count
1771570923	234 Count	297 Count	139 Count
1771569709	221 Count	275 Count	131 Count
1771569403	219 Count	272 Count	131 Count
1771569100	216 Count	268 Count	129 Count
1771568797	210 Count	263 Count	126 Count
1771568493	207 Count	260 Count	124 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)