EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

XE2AD-15 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object XE2AD-15. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1791448863	139 Count	224 Count	99 Count
1791447060	134 Count	220 Count	95 Count
1791445256	129 Count	213 Count	91 Count
1791443453	125 Count	210 Count	88 Count
1791439884	112 Count	202 Count	81 Count
1791438082	108 Count	197 Count	78 Count
1791436277	103 Count	192 Count	74 Count
1791434473	98 Count	188 Count	70 Count
1791432670	94 Count	184 Count	67 Count
1791430867	88 Count	178 Count	62 Count
1791429063	83 Count	173 Count	58 Count
1791427260	78 Count	166 Count	54 Count
1791425456	74 Count	160 Count	51 Count
1791423660	69 Count	153 Count	47 Count
1791420046	60 Count	142 Count	40 Count
1791418280	53 Count	133 Count	38 Count
1791416478	49 Count	122 Count	35 Count
1791414674	46 Count	120 Count	33 Count
1791409264	33 Count	82 Count	23 Count
1791407460	29 Count	77 Count	20 Count
1791405657	25 Count	71 Count	17 Count
1791403853	20 Count	65 Count	13 Count
1791402050	12 Count	36 Count	6 Count
1791400246	7 Count	24 Count	2 Count
1791398443	4 Count	0 Count	0 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)