EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

OK0HCS-1 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object OK0HCS-1. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1791449376	1 Count	130 Count
1791447610	0 Count	70 Count
1791445806	21 Count	1023 Count
1791444003	20 Count	953 Count
1791442200	17 Count	886 Count
1791440397	16 Count	807 Count
1791438594	15 Count	710 Count
1791436791	14 Count	636 Count
1791434987	13 Count	560 Count
1791433184	9 Count	498 Count
1791431381	8 Count	426 Count
1791429578	7 Count	367 Count
1791427775	6 Count	309 Count
1791426011	5 Count	265 Count
1791424207	4 Count	218 Count
1791422405	3 Count	161 Count
1791420601	1 Count	112 Count
1791418798	0 Count	60 Count
1791416995	17 Count	1061 Count
1791415192	16 Count	999 Count
1791413389	15 Count	954 Count
1791411585	14 Count	899 Count
1791409782	13 Count	832 Count
1791407979	12 Count	764 Count
1791406176	11 Count	686 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)