EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

TA4HJ-10 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object TA4HJ-10. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*
1771596493	204 Count	96 Count
1771594690	203 Count	94 Count
1771592924	202 Count	92 Count
1771591121	200 Count	89 Count
1771589318	198 Count	86 Count
1771587515	194 Count	81 Count
1771585712	189 Count	76 Count
1771583909	187 Count	74 Count
1771582105	186 Count	72 Count
1771580302	185 Count	70 Count
1771578499	184 Count	68 Count
1771576696	183 Count	66 Count
1771574892	182 Count	64 Count
1771573089	181 Count	62 Count
1771571323	179 Count	60 Count
1771569520	176 Count	58 Count
1771567716	172 Count	56 Count
1771565913	165 Count	54 Count
1771564110	161 Count	52 Count
1771562307	154 Count	50 Count
1771560504	149 Count	48 Count
1771558701	142 Count	46 Count
1771556898	137 Count	44 Count
1771555095	128 Count	42 Count
1771553292	120 Count	40 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)