EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ9ITQ-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ9ITQ-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1780128940	77 Count	114 Count	3 Count
1780127139	76 Count	114 Count	3 Count
1780125339	75 Count	114 Count	3 Count
1780123538	74 Count	114 Count	3 Count
1780121738	73 Count	114 Count	3 Count
1780119937	72 Count	114 Count	3 Count
1780118136	69 Count	112 Count	1 Count
1780116336	68 Count	112 Count	1 Count
1780114535	67 Count	112 Count	1 Count
1780112740	66 Count	112 Count	1 Count
1780110940	65 Count	112 Count	1 Count
1780109139	64 Count	112 Count	1 Count
1780107338	63 Count	112 Count	1 Count
1780105537	62 Count	112 Count	1 Count
1780103737	61 Count	112 Count	1 Count
1780101936	60 Count	112 Count	1 Count
1780100135	59 Count	112 Count	1 Count
1780098335	58 Count	112 Count	1 Count
1780096534	57 Count	112 Count	1 Count
1780094733	56 Count	104 Count	1 Count
1780092933	55 Count	97 Count	1 Count
1780091139	54 Count	97 Count	1 Count
1780089338	53 Count	97 Count	1 Count
1780087537	52 Count	97 Count	1 Count
1780085737	51 Count	97 Count	1 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)