EA2RCF LoRa APRS MAP Backup

My position About Go to MAIN map Powered by EA2RCF Radioclub Foronda ☰

reset

SQ3MQD-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SQ3MQD-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 3 4 >>

Time	TX*	RX*
1779392024	130 Count	380 Count
1779391120	129 Count	375 Count
1779390217	128 Count	369 Count
1779389313	127 Count	367 Count
1779388410	126 Count	366 Count
1779387507	125 Count	363 Count
1779386604	124 Count	361 Count
1779385701	123 Count	359 Count
1779384798	122 Count	356 Count
1779383894	121 Count	353 Count
1779382991	120 Count	350 Count
1779382088	119 Count	348 Count
1779381185	118 Count	346 Count
1779380282	117 Count	342 Count
1779379378	116 Count	342 Count
1779378475	115 Count	339 Count
1779377572	114 Count	338 Count
1779376669	113 Count	337 Count
1779375766	112 Count	334 Count
1779374862	111 Count	333 Count
1779373959	110 Count	332 Count
1779373132	109 Count	329 Count
1779372229	108 Count	327 Count
1779371326	107 Count	326 Count
1779370423	106 Count	323 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)